CC4 Pro digital 360° camera wiring guide

Use this guide for the four digital surround-view cameras on the CC4 Pro. The dedicated camera sockets are labelled FRONT, RIGHT, REAR and LEFT on the back of the unit.

Connect the camera harness

  1. With the head unit powered off, match each of the four digital camera leads to its labelled socket.
  2. Connect each side camera’s separate indicator trigger lead to its corresponding turn signal on the vehicle side and to the matching trigger connection on the B-port harness at the head-unit end. The digital camera plugs themselves go to RIGHT and LEFT.
  3. If the CANBUS decoder already supplies reverse to G5, leave that connection in place and leave both reverse-trigger pigtails on the 6 m rear video cable disconnected. Otherwise, connect the vehicle reverse signal to the rear cable’s vehicle-end trigger lead and connect the head-unit-end trigger lead to G5 as shown.
  4. Switch from front/rear recording to 360° surround-view mode and follow the activation guide. Use the unique activation card supplied with the kit when prompted.

Check the views before finishing

With the vehicle stationary and secured, check that each camera appears in the correct position and that reverse and each indicator trigger the expected view. Calibrate the surround view with the kit’s calibration equipment before relying on it.

Wiring diagram

CC4 Pro digital 360° camera wiring guide showing camera connections and trigger wiring
Select the diagram to open it at full size.

CC4 Pro Digital 360 activation guide · CC4 analogue wiring guide